FIBEROCK® Aqua-Tough™ Interior Panels
Ideal
for institutional, commercial, and residential
interiors.
They offer exceptional resistance to sounds, abuse, water, mould, and fire.
|
Product Features
Literature
FAQs
Related Products
With increased resistance to indentation and penetration, FIBEROCK Aqua-Tough interior panels outperform speciality plasterboard and fibre cement panels. They are suitable for use on walls, ceilings, and exterior dry soffit applications, offering abuse-, moisture-, mould-, and fire-resistance. These high-performance panels derive both strength and water resistance from their uniform composition. As a result, they won’t lose their strength when cut. And they are ideal for wet areas, because their panel surface will not delaminate when wet. They provide a smooth, paintable surface that can also be finished with ceramic tile. One type of panel can be used for an entire room, simplifying design and installation, shortening job schedules and lowering in-place costs. They are made from 95-percent recycled materials, an environmentally friendly option for use in sustainable building construction.
Distribution and HandlingQ: Can I lean FIBEROCK® Brand Panels against walls? A: FIBEROCK® Brand Panels are very heavy and strong and should be stacked flat on the floor. Serious injury can occur from falling panels. Q: What size does Powerscape FIBEROCK® come in? A: FIBEROCK® Brand Panels come in the following nominal sheet sizes: Q: What is the weight of Powerscape FIBEROCK®? A: FIBEROCK® Brand Panels Nominal Density and Weight: Q: What are the edge profiles for Powerscape FIBEROCK®? A: FIBEROCK® Brand Panels come with the following edge profiles: Q: Do I need control joint where FIBEROCK® Brand Panels meets Plasterboard? A: If the plasterboard is the same thickness, then no. For plasterboard of a different thickness, or wall board of a different type (e.g. fibre cement), a control joint is required. Q: How often is a control required in FIBEROCK®? A: Control joints relieve stresses imposed by structural movement including those due to excessive changes in temperature and humidity. In long unbroken partitions or wall runs, control joints are required at 12 metre centres. They are also required where structural control joints occur in the primary structure and where USG Powerscape® interior linings meet dissimilar materials, except plasterboard of the same thickness. Door frames extending from floor to ceiling constitute an effective control joints. Control joint should be backed by double framing spaced 12.5mm apart. Install control joints as per manufacturer's instructions. Suitable control joints include the USG Zinc Control Joint No.093 and the Rondo P35 control joint. Q: What isPowerscape FIBEROCK® Brand Panels made off? A: FIBEROCK® Brand Panels are 85% recycled industrial gypsum, 10% recycled cellulose (cardboard), and the remaining 5% is water and binding materials. Fiberock is classified as formaldehyde free. |
